Epson Equity 286 PLUS User Manual

Page 162

7. To replace the front panel, fit the three ridged tabs on its

bottom edge into the three notches on the lower edge of the
computer, as shown below.

notches

tabs

Tilt up the front panel until the clips on the top touch the
computer. Then push on the top of the panel until it clicks

into place. Your diskette drive(s) should be flush with the

front of the panel.

Follow the steps on page 5-41 to replace the computer’s
cover. Then see “Post-installation Setup” later in Chapter 5

for instructions on configuring your computer for use with
your new hard disk drive.

Note
After you change your computer’s drive configuration, the

computer may take several minutes to complete power-on
diagnostics the next time you turn it on.

Installing and Removing Disk Drives

B-23