Epson Equity 286 PLUS - Manual (Page 133)

If you want to use any of the memory on your card as
expanded memory, see “Using Expanded Memory Beyond
1MB” in Chapter 4.
Also see “Post-installation Setup,” below, for more information
on setting up your computer for use with an option card.
Using the CORFIX Program
To configure your computer for use with the Rampage Plus 286+
memory card, you need to run CORFIX, an Epson utility on
your Reference diskette, and SMART, the Rampage Plus 286+
setup program. You must run CORFIX before you use SMART.
If you have a hard disk, you can copy CORFIX.EXE from your
Reference diskette to your hard disk before you run it. Then
follow these instructions to run CORFIX:
1. Turn on your computer. Make sure the MS-DOS command
prompt appears on the screen. If you do not have a hard disk
(or you did not copy CORFIX to your hard disk), insert your
Reference diskette in drive A. Type A: and press Enter to
log onto drive A.
2. At the MS-DOS prompt, type CORFIX and press Enter.
The following messages appear:
The program will configure the
system to work with the SMART
utility when installing the Rampage
plus 286.
SMART can only be executed
immediately after this configuration
program. Continue ? (Y/N)
Installing and
Removing Options
5-43