Espeed l, Type espeed, Speed up – Epson Equity 286 PLUS User Manual
Page 78: Speed down : exit, Espeed l sample, Samp
The message tells you the switches you should use to set the
speed to high or low. At the MS-DOS prompt, type the
ESPEED command again and include the appropriate switch,
such as the following:
ESPEED L
This command changes the processor speed to low.
To
see
the current CPU speed,
type ESPEED
only and press
Enter. You
see the following:
< + >
: Speed Up
1 2 . 0 M H Z < - >
: Speed Down
The processor speed you set remains in effect until you press the
RESET
button or turn off the computer, or until you change it
using the SETUP program, a keyboard command, or the
ESPEED
program again.
Entering the ESPEED command in a batch file
You may want to run the ESPEED program by including the
command in a batch file. For example, if you have a program
called
SAMPLE
which requires a slower processor speed, you
could include the following commands in a batch file to start
the
SAMPLE
program:
ESPEED L
SAMPLE
You could name the batch file
SAMP.BAT.
Whenever you
need to run the
SAMPLE
program, insert the program diskette
in drive A. Then type
SAMP
and press
Enter.
The computer
changes the speed to low and starts the SAMPLE program.
See your MS-DOS Reference Manual for instructions on
creating and using batch files.
4-6
Enhancing System
Operations