Epson Equity 286 PLUS - Manual (Page 109)

Follow these steps to remove the subassembly:
1. Remove the front panel from the computer by lifting up
slightly on the three clips at the top of the panel and tilting
it toward you. Then set it aside.
clips
front panel
2. If you have a hard disk drive, the drive cable is connected to
the main system board on the left side of the subassembly, as
shown below.
Grasp the connector and pull it straight up to remove it
from the socket. Do not pull only on the cable.
InstalIing
and Removing Options 5-19