beautypg.com

Setting the built-in interfaces, Setting the parallel interface, Lp t 1 – Epson Equity 286 PLUS User Manual

Page 49: Lpt2, Lpt3

background image

Setting the Built-in Interfaces

This option lets you define how the following built-in interfaces

in your computer operate:

Parallel port (LPT1 , LPT2, LPT3)

Serial port (COMl or COM2)

Hard disk drive controller (HDC)

Floppy disk drive controller (FDC).

Read the following descriptions to make sure the settings are

correct.

Setting the Parallel Interface

The built-in parallel port in your computer is set to act as the

primary port (LPTl). If you install an option card that provides
an additional parallel interface’ you may need to select LPT2 or
LPT3 for the built-in port. Follow these guidelines:

If you are using only the built-in port, select

LP T 1 .

Also

select LPTl if you have installed an additional port but want
to keep the built-in port the primary adapter.

If you have installed an additional port that is pre-set to act
as the primary port or one that you want to be the primary

port, select

LPT2

. For example, if you have installed an

IBM monochrome adapter/parallel interface card, the
parallel port on the card must be the primary adapter and
you need to select LPT2 for the built-in port.

If you have installed two additional parallel ports and you
want them to be the primary and secondary ports, select

LPT3.

2-14

Running the Setup Program