beautypg.com

Turning off the computer, Press to start setup – Epson Equity 286 PLUS User Manual

Page 35

background image

When the system has successfully completed its self test, you see

the following prompt:

Press to start SETUP

Do not press any key yet. If MS-DOS has already been installed

on your system, you’ll see a prompt to enter the date. (For

information about loading the operating system, see your

MS-DOS Installation Guide or Reference Manual.)

If there is no operating system on your computer, you see an
error message. Ignore the message for now. Follow the
instructions below to turn off the computer and then go on to

Chapter 2 for instructions on running the SETUP program.

N o t e

If your computer’s configuration does not match the
information stored in the computer’s CMOS RAM (defined
through the SETUP program) you see an error message and a

prompt to press the

F1

key. Press

F1

to continue. You need

to run the SETUP program to correct the information. See
Chapter 2 for instructions.

Turning Off the Computer

When you are ready to turn off your system, reverse the

sequence of steps you followed to turn it on. Turn off the
computer first, then turn off the monitor and any peripheral
devices.

Now go on to Chapter 2 and follow the instructions to run the
SETUP program.

1-18

Setting Up

Your System