beautypg.com

Epson Equity 286 PLUS User Manual

Page 145

background image

The following table lists the jumper settings for all the possible
hard disk drive configurations.

X

= jumper installed

- = no jumper installed

To move a jumper from one position to the other, use your
fingers, needle-nose pliers, or tweezers to pull it off its pins and
gently move it to the other position. Be careful not to drop the
jumper or damage the pins as you install it.

If you are going

to

use only one hard disk drive, the jumpers

should be set in positions

C/D

and

ACT.

If not, change them to

these settings. Then see “Installing a Hard Disk in the Vertical
Position” on page B-7 for instructions on installing your first
hard disk drive.

If you’ll be using two hard disk drives, you have a total of four

jumpers for eight jumper positions. Two jumpers are included
with each drive. Install three of the jumpers on the master drive

in positions

C/D, DSP,

and

ACT.

Install the fourth jumper on

the slave drive in position

ACT.

If you are installing both of your hard disk drives at one time,

you should install the drive in the horizontal drive bay first. See
“Installing or Removing a Disk Drive in the Horizontal

Position” on page B-27 for instructions.

B-6

Installing

and

Removing Disk Drives