Epson Equity 286 PLUS - Manual (Page 182)

Removing a Disk Drive From the Horizontal Position
The figures in this section show a diskette drive in the lower
horizontal drive bay, but you can use the same instructions to
remove a hard disk drive from the lower bay or to remove a
diskette drive from the upper bay.
Follow these steps to remove a drive from a horizontal drive bay:
1. Remove the disk drive ribbon cable from the back of the
drive, as shown below.
ribbon cable
connector
2. Remove the power supply connector from the back of the
drive. It is located near the ribbon cable interface, as shown
in the next illustration.
Installing and Removing Disk Drives B-43