beautypg.com

Replacing the drive on the subassembly, B-41 – Epson Equity 286 PLUS User Manual

Page 180

background image

Replacing the Drive on the Subassembly

This section describes how to reinstall your hard disk drive in

the vertical mounting position. The following illustrations show
the subassembly installed inside the computer with the front

panel attached. However, if your subassembly is out of the
computer you can install the drive in the manner described
below. Follow these steps:

1.

Pick up the hard disk drive and hold it above the right side
of the subassembly with the mounting plate facing the
subassembly, as shown below.

Notice that there are two tabs facing downward on the
bottom of the mounting plate. These tabs will fit into two
slots in the right side of the subassembly.

Installing and Removing Disk Drives

B-41