Epson Equity 286 PLUS - Manual (Page 25)

Note
If you install a display adapter card, you must set jumper J3 on
the main system board to disable the built-in VGA interface
so that your card can operate as the primary display adapter.
You may also need to set jumper J5 to indicate whether a
color or monochrome monitor is installed. See Chapter 5 for
instructions on changing jumper settings.
Once you have installed your video card, return to this section
to connect your monitor to the computer. If your monitor came
with its own manual, follow the instructions there. Otherwise,
you can follow the steps in “Using the VGA Interface” above;
just insert your monitor connector into the video card port
instead of the built-in VGA port.
4 Connecting a Printer or Other Device
Your computer has both parallel and serial interfaces. T O
connect a printer or other peripheral device to one of these
interfaces, follow the instructions below. Of course, Epson offers
a full range of printers; ask your dealer for more information.
Using the Parallel Interface
The parallel interface on your computer is Centronic
®
compatible and uses a DB-25S connector.
To connect your printer and computer, you need an IBM
compatible printer cable. If you are not sure which one you
need, check with your Epson dealer.
1-8 Setting Up Your System