beautypg.com

Exiting system diagnostics, C-25 – Epson Equity 286 PLUS User Manual

Page 219

background image

If you see one of the following errors, there may be a problem

with the controller or the test cable:

Error - Break detected
Error - Framing error
Error - Overrun error
Error - Parity error

Error - Time out!

Check to make sure that the test connector is securely
connected to the port. If the error persists, contact your dealer.

Exiting System Diagnostics

To exit from the System diagnostics program, press E

SC

You see

the following prompt:

DO YOU want to exit diag (Y/N)? N

Before you press a key, remove the Reference diskette from drive

A. If you do not have a hard disk, insert your MS-DOS Startup
diskette in the drive. Then press Y and

Enter to

exit

the

program. You see this message:

Stand by while system is rebooting.

The computer loads MS-DOS and you see either the

C>

or

A>

prompt.

Performing System Diugnostics

C-25