Post-installation setup – Epson Equity 286 PLUS User Manual
Page 134
3.
To run the program, press Y. To exit without running
CORFIX,
press
N.
If you press Y, you see the MS-DOS
prompt and this message:
Configuration completed. The SMART
installation utility may now be
used.
4.
Use the
SMART
setup program now. See your RampagePlus
286+ manual for instructions.
Post-installation Setup
After you install or remove options such as memory modules, a
math coprocessor, or a disk drive, you need to run the SETUP
program to update the computer’s configuration information.
For example, if you add a hard disk drive, you need to let the
computer know the type of drive you have installed. See
Chapter 2 for instructions.
If you replaced the battery for the real-time clock and CMOS
RAM, you must run SETUP to reconfigure your system and reset
the clock. See Chapter 2.
N o t e
If you installed additional extended memory and want to use
any of it as expanded memory, see “Using Expanded Memory
Beyond
1MB"
in Chapter 4 for instructions.
If you install a hard disk drive that has never received a
hardware level format (such as some non-Epson hard disk
drives), you need to format the disk. Check the manual that
came with your drive, and then, if necessary, follow the
instructions in Appendix C to format your new hard disk.
5-44
Installing and Removing Options