Accessing your curent password – Epson Equity 286 PLUS User Manual
Page 225
Accessing Your Current Password
If you have forgotten your current password and cannot use your
computer, follow these steps:
1.
2.
3.
4.
5.
6.
Turn off the computer and follow the instructions under
“Changing the Jumper Settings” in Chapter 5 to disable the
password function by setting jumper J6 to position A.
Caution
Be sure to ground yourself on the back inside panel of
the computer before touching any of the interior
components. Always replace the cover on the computer
before you turn it on again.
Turn on the computer. You do not see the
Password
:
prompt.
When the
Press to start SETUP
prompt appears, press
Del.
Highlight
Run SETUP
and press
Enter. You
see the
SETUP menu. Your current password is displayed near the
bottom of the screen.
If you still want to use the same password, be sure to
remember it or write it down. Then go to step
6.
If you want to change or delete your current password,
follow the instructions under “Setting the Password”
in
Chapter 2. Be sure to save your SETUP information when
you exit the program.
Turn off the computer and follow the instructions under
“Changing the Jumper Settings” in Chapter 5 to enable the
password function by setting jumper J6 to position B.
D-6 Troubleshooting