Epson Equity 286 PLUS - Manual (Page 201)

If you select Log errors on disk, the program displays
this submenu:
Floppy disk A:
Floppy disk B:
Hard disk C:
Hard disk D:
Press ” or “ to highlight the disk on which you want to log the
error messages and press
Enter. (You do not see drive D unless
you have a second hard disk drive.) The program creates a file
called ERROR.LOG in the current directory of the specified
disk drive. After running the tests, you can open the
ERROR.LOG file to review the errors that occurred during the
tests.
The program uses this device for error logging until you change
it or indicate you do not want error logging. When you specify a
new device, the program erases the existing ERROR.LOG file, if
any.
When you specify the device for error logging, one of these error
messages may appear:
Floppy disk A not present
Floppy disk B not present
Hard disk C not present
Printer port not present
Serial port not present
Error in printer status
Error in serial port status
Error in floppy drive A
Record the error message and select a different device for error
logging.
Once you set the Run time parameters, you are ready to select
the test(s).
Performing System Diagnostics C-7