KACO Powador XP500-XP550-HV TL - Manual (Page 43)

Operating Instructions Powador XP500/550-HV-TL Page 43
Storage/Installation/Start-up
Software upgrade
MMI
Start
Synchronyzing flash system
and SD-card controller
Software upgrade
MMI
Start
Software upgrade done!
Auto reboot after 5 sec. ...
Figure 39: Upgrade process progress bar Figure 40: Restart dialog box
ATTENTION
Software damage due to an interruption of the synchronisation process
If the synchronising of the flash file system and the content of the SD card is
interrupted (e.g. due to a power failure), the software can be damaged and
the MMI may not be able to restart.
Update the C6x software
SAFE
NOTE
Do not remove the SD card until the SAFE icon is displayed so that it will be detected by the
MMI when you reinsert it.
Update the C6x software
Perform the following steps in the indicated sequence:
" Make sure that the RS232 cable between the MMI and the control unit is connected.
" Switch off the inverter. To do so, press the OFF button in the main menu.
" Copy the software file (*.hex) to the SD card.
" Insert the SD card into the MMI.
" Select “Setup” → “Software upgrade”.
" Select “C6x” and press “Start”.
A dialog box for opening files is then displayed.
" Select the file that you copied earlier.
" Press the “Open” button.
The MMI transfers the file to the control unit. If the file transfer was successful, the following message will
appear:
“MMI has finished upgrading XCU.”
The control unit has now been successfully upgraded.
An error message indicates that the process was not successfully completed.
" Press the ON button in the main menu to activate system operation.