KACO Powador XP500-XP550-HV TL - Manual (Page 33)

Operating Instructions Powador XP500/550-HV-TL Page 33
Storage/Installation/Start-up
5.9 MMI main menu
ON OFF
Circuit breaker
CB10 Speaker
SD card Circuit breakers
MC21 + CB20
Fault History Statistics Setup
701.0V 380.0V
75.8kW 79.0kW
45.0°C
Date/Time
Displayed button colors
Colour Meaning
Green Normal operation
Red
Fault (not for switches CB10, MC21
and CB20)
Grey Not in use
Figure 20: Display when the MMI starts up
5.9.1 Changing the SD card, status display
DANGER
Lethal voltages are still present in the terminals and lines of the inverter even after
the inverter has been switched off and disconnected!
Coming into contact with the lines and terminals in the inverter will cause serious
injury or death.
Only authorised electricians who are approved by the supply grid operator may open,
install and maintain the inverter.
› Keep all doors and covers closed when the unit is in operation.
› Do not touch the lines and terminals when switching the unit on and off!
Insert the SD card
“No SD in slot” icon
" Open the inverter. The inverter shuts down.
" Slide the SD card into the slot until it locks into place.
" Close the inverter.
" Press the ON button. The inverter starts up.
“SD card in slot” icon
The inverter checks the card. If the SD card was detected, the “SD card in slot” icon appears in
the lower right-hand corner of the display.
" Press the SD card icon.
" Wait until the SAFE icon is displayed.