Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 32)

5 - 9
YASNAC PCNC PLC Programming Manual Chapter 5: Address Numbers And Map
(9) Addresses of Sequencer Parameters (pm7000 to pm7099)
For the sequencer parameters, address pm #7000 to pm7099 are assigned. The data set for
sequencer parameters can be changed by using the normal parameter write operation. When
using the data of these parameters in a sequence parameter, the following two methods are
available.
• To use as one-bit data
• To use as one-byte data
(a) Using as one-bit data
Example:
The symbol used in the ladder is indicated below.
(b) Using as one-byte data
Example:
In this case, the address number itself is used as the symbol.
See the example below where a parameter is used with a timer instruction.