Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 110)

6 - 74
YASNAC PCNC PLC Programming Manual Chapter 6: PLC Instructions
• Designation of the number of conversion table (TPSH#XXXX)
The size of the table differs depending on the PLC number.
9000 to 9007: Max. 256 bytes
9008 to 9023: Max. 128 bytes
• Designation of the size of the data in conversion table (IPSHX)
IPSH e = 1: 1 byte
IPSH e = 2: 2 byte
IPSH e = 3: 4 byte
• Reset (RST)
RST = 0: Error output R1 is not reset.
RST = 1: Error output R1 is reset.
• Execution command (ACT)
ACT = 0: The binary decode conversion instruction is executed. R1 remains
unchanged.
ACT = 1: The binary decode conversion instruction is not executed.
• Error output (R1)
R1 = 0: Normal
R1 = 1: Error
A numeric value greater than the table size is set.