Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 210)

11 - 11
YASNAC PCNC PLC Programming Manual Chapter 11: YASNAC Paradym-31 DLL
11.10 Error Message that Occurred in DLL Function
In each DLL, an error status is displayed in the message box during error occurrence.
For example:
11.11 Additional Parameters
pm5014 d5: Paradym-31 debug mode selection parameter
0: Invalidate the communication between the Paradym-31 and CNC device
1: Validate the communication between the Paradym-31 and CNC device.
• This parameter set-up requires power-off.
• This parameter is enabled only when the system number switch is “4”.
11.12 Other Restrictions
(1) If NC power is input when system number switch is “4”, and the pm5014 d5 is “1”, the
ladder display is disabled.