Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 105)

6 - 69
YASNAC PCNC PLC Programming Manual Chapter 6: PLC Instructions
• Designation of the display screen number (IPSHX)
Designate the display page number to be used.
A total of two pages (No. 1 and No. 2) can be used for both the high-speed
processing and low-speed processing sequence programs.
• Designation of the start address of the PLC table containing the message
(TPSHXXXX)
(d) Example 2
When the contact of AL 1 to AL4 is turned ON, the message corresponding to the
ON bit is displayed on the screen and the machine operation stops after deceleration.
The display is cleared when the reset signal is input.