Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 201)

11 - 2
YASNAC PCNC PLC Programming Manual Chapter 11: YASNAC Paradym-31 DLL
11.1 Outline
This specification sheet explains the Dynamic Link Library (hereinafter, DLL) (for
Windows) which enables the connection and on-line debug of sequence program
development software YASNAC Paradym-31 (hereinafter, Paradym-31) and a CNC device
(YASNAC PCNC series). (The Paradym-31 has three debug methods: dual port, Ethernet,
and RS-232C. YASNAC uses only the RS-232C.)
11.2 System Outline Diagram
The YASNAC sequence program debug is performed by connecting and communicating the
Paradym-31 with the CNC device via the RS-232C.
Refer to YASNAC Paradym-31 Sequence Program Development Environment Set-up
Manual for the cable specification.
Windows-NT4.0
YASNAC Paradym-31
Sequence Debug
RS-232C
It is possible to communicate with
the Paradym-31 when system number
switch is “4” and pm5014 d5 is “1”.
• Sequence program compilation/link
• Sequence execution module download
• Sequence start/stop
• Contact data monitoring