Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 183)

8 - 35
YASNAC PCNC PLC Programming Manual Chapter 8: Online Editing
The conversion data editing procedure is explained below.
€ After displaying the conversion data page of the required conversion data number,
press the [ INS ] key.
The cursor appears on the first byte position in the data display area.
ó Move the cursor to the data to be changed. Key-in the required numeric value and
press the enter key.
Example: [4][2][W]
ì Press the [
INS ] key.
8.5.2 Editing the Data in Message Table
The message data that has been set by using the pseudo instruction “MESSAGE” can be edited.
Up to 40 characters can be input as message data.
Fig. 8.21 shows the message data edit screen.
The message data number is #9024 to #9323.
Fig. 8.21 message Data Edit Screen
The message data editing procedure is explained below.
€ Move the cursor to the message data number of the message that should be changed.
ó Key-in the required numeric value and press the ENTER key.