Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 137)

7 - 10
YASNAC PCNC PLC Programming Manual Chapter 4: Sequence Control Method
• Conversion data source file
Write the conversion table which is used by macro instruction SUBP007.
Although there are no restrictions on the data start line or column, at least one,
space must be placed between the table number and data.
A table number must begin with “N”.
Delimiter “,” is used between data.
• The table numbers that can be used are indicated below.
#9000 to #9007: 256bytes
#9008 to #9023: 128bytes
In normal format, data are stored in the ladder table as byte data.
To store word data, place an underscore preceding the numeric values..