Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 195)

10 - 5
YASNAC PCNC PLC Programming Manual Chapter 10: YASNAC Paradym-31
10.4 Preface
This document explains the procedures and restrictions for performing an on-line debug based
on software YASNAC Paradym-31 (hereinafter, Paradym-31) used for sequence program
development. Refer to Paradym-31 Users Guide/Reference Book for general Paradym-31
operation methods.
10.5 Function Outline
The sequence program debug can be performed by connecting a Paradym-31-installed PC and
an NC device (YASNAC PCNC).
Possible debug functions performed by the Paradym-31 are as follows.
• Sequence program compilation and link
• Sequence execution module download
• Start/Stop of the sequence downloaded in the YASNAC PCNC
• Contact data monitoring
Windows-NT4.0
YASNAC Paradym-31
Sequence Debug
RS-232C
It is possible to communicate with
the Paradym-31 when system number
switch is “4” and pm5014 d5 is “1”.
• Sequence program compilation/link
• Sequence execution module download
• Sequence start/stop
• Contact data monitoring