Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 190)

9 - 3
YASNAC PCNC PLC Programming Manual Chapter 9: Downloading & Uploading Sequence Program
ö Highlight the “lader” path name. Hit the “Modification” button and make the path point to
the a:\ drive.
ú Once you found your binary file hit enter and again highlight “lader” path name.
÷ Next hit “PC -> NC” button to start download.
ø When finished hit “End” and reboot.
9.2 Uploading Sequence Program (Flash ROM
Å Floppy Disk)
The procedure for uploading the sequence program from floppy disk to PC card is
indicated below.
€ Carry out steps € to ú described in section 9.1.
ó Press the [NC Å PC] function soft-key.
ì Turn the SW1 to OFF and turn the power OFF.