SMA WEBBOX-BT-20 - Manual (Page 60)

Managing Plant Data SMA Solar Technology AG
60 SWebBox20-BA-en-13 User Manual
8.2.7 Adjusting the Plant Identifier for Sunny Portal
In the following cases, you must adjust the plant identifier of the Sunny WebBox:
• The plant data of the PV plant in question has already been sent to Sunny Portal via another
communication device.
• The plant identifier set for the Sunny WebBox was reset using the Reset button.
• The Sunny WebBox has been replaced with another Sunny WebBox.
• The WebBox is to be added to a plant that is already registered in Sunny Portal.
Perform the following steps to adjust the plant identifier of the Sunny WebBox for Sunny Portal:
1. Log into Sunny Portal with the available access data (www.SunnyPortal.com).
2. On the Sunny Portal page, select "Configuration > Plant Properties".
3. Copy the plant identifier to the clipboard.
4. Log into the Sunny WebBox as a user or installer.
5. On the Sunny WebBox user interface, select the Sunny WebBox in the plant tree.
6. Select "Settings" in the device menu.
7. Select the "Sunny Portal > User settings" parameter group.
8. Select [Edit].
9. In the "Plant ID" field, delete the current content and paste in the content of the clipboard.
10. Select [Save].
8.3 SD Card
8.3.1 Information on Saving Plant Data on an SD Card
You can save your plant data onto an SD card. Once you have inserted the SD card into the
SD card slot, the Sunny WebBox copies all the plant data that is stored on the internal drive of the
Sunny WebBox onto the SD card. The Sunny WebBox saves new plant data onto the SD card as long
as the SD card is inserted in the SD card slot and there is enough memory space available. To select
a data format in which the data is to be provided, refer to Section 7.6 ”Data Recording” (page 50).