HEIDENHAIN TNC 320 (34055x-06) Cycle programming - Manual (Page 376)

Touch Probe Cycles: Special Functions
17.5 CALIBRATE TS (Cycle 460, DIN/ISO: G460)
17
376
TNC 320 | User's Manual Cycle Programming | 5/2013
Reference angle Q380 (absolute): Reference
angle (basic rotation) for measuring the measuring
points in the active workpiece coordinate system.
Defining a reference angle can considerably enlarge
the measuring range of an axis. Input range 0 to
360.0000
Calibrate length (0/1) Q433: Define whether the
TNC is to calibrate the touch probe length after
radius calibration, as well:
0 : Do not calibrate touch probe length
1 : Calibrate touch probe length
Datum for length Q434 (absolute): Coordinate of
the calibration sphere center. The definition is only
required if length calibration is to be carried out.
Input range -99999.9999 to 99999.9999