HEIDENHAIN TNC 320 (34055x-06) Cycle programming - Manual (Page 356)

Touch Probe Cycles: Automatic Workpiece Inspection
16.10 MEASURE RIDGE WIDTH (Cycle 426, DIN/ISO: G426)
16
356
TNC 320 | User's Manual Cycle Programming | 5/2013
16.10 MEASURE RIDGE WIDTH (Cycle 426,
DIN/ISO: G426)
Cycle run
Touch Probe Cycle 426 measures the position and width of a ridge.
If you define the corresponding tolerance values in the cycle, the
TNC makes a nominal-to-actual value comparison and saves the
deviation value in system parameters.
1 The TNC positions the touch probe at rapid traverse (value from
FMAX column) following the positioning logic (See "Executing
touch probe cycles", page 259) to the starting point
1 . The TNC
calculates the touch points from the data in the cycle and the
safety clearance from the
SET_UP column of the touch probe
table.
2 Then the touch probe moves to the entered measuring height
and runs the first probing process at the probing feed rate
(column
F). 1. The first probing is always in the negative
direction of the programmed axis.
3 Then the touch probe moves at clearance height to the next
starting position and probes the second touch point.
4 Finally the TNC returns the touch probe to the clearance height
and saves the actual values and the deviation value in the
following Q parameters:
Parameter number Meaning
Q156 Actual value of measured length
Q157 Actual value of the centerline
Q166 Deviation of the measured length
Please note while programming:
Before a cycle definition you must have programmed
a tool call to define the touch probe axis.
Cycle parameters
1st meas. point 1st axis Q263 (absolute):
Coordinate of the first touch point in the reference
axis of the working plane. Input range -99999.9999
to 99999.9999
1st meas. point 2nd axis Q264 (absolute):
Coordinate of the first touch point in the minor axis
of the working plane. Input range -99999.9999 to
99999.9999
2nd meas. point 1st axis Q265 (absolute):
Coordinate of the second touch point in the
reference axis of the working plane. Input range
-99999.9999 to 99999.9999