HEIDENHAIN TNC 320 (34055x-06) Cycle programming - Manual (Page 30)

Contents
30
TNC 320 | User's Manual Cycle Programming | 5/2013
15.9 DATUM FROM INSIDE OF CORNER (Cycle 415, DIN/ISO: G415).....................................................312
Cycle run.................................................................................................................................................312
Please note while programming:........................................................................................................... 312
Cycle parameters................................................................................................................................... 313
15.10 DATUM CIRCLE CENTER (Cycle 416, DIN/ISO: G416).......................................................................315
Cycle run.................................................................................................................................................315
Please note while programming:........................................................................................................... 315
Cycle parameters................................................................................................................................... 316
15.11 DATUM IN TOUCH PROBE AXIS (Cycle 417, DIN/ISO: G417)...........................................................318
Cycle run.................................................................................................................................................318
Please note while programming:........................................................................................................... 318
Cycle parameters................................................................................................................................... 319
15.12 DATUM AT CENTER OF 4 HOLES (Cycle 418, DIN/ISO: G418).........................................................320
Cycle run.................................................................................................................................................320
Please note while programming:........................................................................................................... 320
Cycle parameters................................................................................................................................... 321
15.13 DATUM IN ONE AXIS (Cycle 419, DIN/ISO: G419)............................................................................323
Cycle run.................................................................................................................................................323
Please note while programming:........................................................................................................... 323
Cycle parameters................................................................................................................................... 323
15.14 Example: Datum setting in center of a circular segment and on top surface of workpiece..........325
15.15 Example: Datum setting on top surface of workpiece and in center of a bolt hole circle............. 326