HEIDENHAIN TNC 320 (34055x-06) Cycle programming User Manual

Page 19

TNC 320 | User's Manual Cycle Programming | 5/2013

Fixed Cycles: Contour Pocket........................................................................................................153

7.1

SL Cycles............................................................................................................................................... 154

Fundamentals......................................................................................................................................... 154

Overview................................................................................................................................................ 155

7.2

CONTOUR (Cycle 14, DIN/ISO: G37).................................................................................................. 156

Please note while programming:........................................................................................................... 156

Cycle parameters................................................................................................................................... 156

7.3

Superimposed contours...................................................................................................................... 157

Fundamentals......................................................................................................................................... 157

Subprograms: overlapping pockets........................................................................................................ 157

Area of inclusion.................................................................................................................................... 158

Area of exclusion................................................................................................................................... 158

Area of intersection................................................................................................................................159

7.4

CONTOUR DATA (Cycle 20, DIN/ISO: G120)......................................................................................160

Please note while programming:........................................................................................................... 160

Cycle parameters................................................................................................................................... 161

7.5

PILOT DRILLING (Cycle 21, DIN/ISO: G121)...................................................................................... 162

Cycle run.................................................................................................................................................162

Please note while programming:........................................................................................................... 162

Cycle parameters................................................................................................................................... 163

7.6

ROUGHING (Cycle 22, DIN/ISO: G122).............................................................................................. 164

Cycle run.................................................................................................................................................164

Please note while programming:........................................................................................................... 165

Cycle parameters................................................................................................................................... 166

7.7

FLOOR FINISHING (Cycle 23, DIN/ISO: G123)...................................................................................167

Cycle run.................................................................................................................................................167

Please note while programming:........................................................................................................... 167

Cycle parameters................................................................................................................................... 167

7.8

SIDE FINISHING (Cycle 24, DIN/ISO: G124)...................................................................................... 168

Cycle run.................................................................................................................................................168

Please note while programming:........................................................................................................... 168

Cycle parameters................................................................................................................................... 169