HEIDENHAIN TNC 320 (34055x-06) Cycle programming - Manual (Page 111)

HELICAL THREAD DRILLING/MILLING (Cycle 265, DIN/ISO: G265) 4.9
4
TNC 320 | User's Manual Cycle Programming | 5/2013
111
Feed rate for countersinking Q254: Traversing
speed of the tool during countersinking in mm/min.
Input range 0 to 99999.9999 alternatively
FAUTO,
FU
Feed rate for milling Q207: Traversing speed of
the tool in mm/min while milling. Input range 0 to
99999.999 alternatively
FAUTO
NC blocks
25 CYCL DEF 265 HEL. THREAD DRLG/
MLG
Q335=10 ;NOMINAL DIAMETER
Q239=+1.5 ;THREAD PITCH
Q201=-16 ;THREAD DEPTH
Q253=750 ;F PRE-POSITIONING
Q358=+0 ;DEPTH AT FRONT
Q359=+0 ;OFFSET AT FRONT
Q360=0 ;COUNTERSINKING
Q200=2 ;SET-UP CLEARANCE
Q203=+30 ;SURFACE COORDINATE
Q204=50 ;2ND SET-UP
CLEARANCE
Q254=150 ;F COUNTERBORING
Q207=500 ;FEED RATE FOR
MILLING