HEIDENHAIN TNC 320 (34055x-06) Cycle programming - Manual (Page 29)

TNC 320 | User's Manual Cycle Programming | 5/2013
29
15 Touch Probe Cycles: Automatic Datum Setting.......................................................................... 281
15.1 Fundamentals....................................................................................................................................... 282
Overview................................................................................................................................................ 282
Characteristics common to all touch probe cycles for datum setting....................................................284
15.2 DATUM SLOT CENTER (Cycle 408, DIN/ISO: G408)..........................................................................286
Cycle run.................................................................................................................................................286
Please note while programming:........................................................................................................... 286
Cycle parameters................................................................................................................................... 287
15.3 DATUM RIDGE CENTER (Cycle 409, DIN/ISO: G409)........................................................................ 289
Cycle run.................................................................................................................................................289
Please note while programming:........................................................................................................... 289
Cycle parameters................................................................................................................................... 290
15.4 DATUM FROM INSIDE OF RECTANGLE (Cycle 410, DIN/ISO: G410)............................................... 292
Cycle run.................................................................................................................................................292
Please note while programming:........................................................................................................... 293
Cycle parameters................................................................................................................................... 293
15.5 DATUM FROM OUTSIDE OF RECTANGLE (Cycle 411, DIN/ISO: G411)........................................... 296
Cycle run.................................................................................................................................................296
Please note while programming:........................................................................................................... 297
Cycle parameters................................................................................................................................... 297
15.6 DATUM FROM INSIDE OF CIRCLE (Cycle 412, DIN/ISO: G412)....................................................... 300
Cycle run.................................................................................................................................................300
Please note while programming:........................................................................................................... 301
Cycle parameters................................................................................................................................... 301
15.7 DATUM FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413)................................................... 304
Cycle run.................................................................................................................................................304
Please note while programming:........................................................................................................... 304
Cycle parameters................................................................................................................................... 305
15.8 DATUM FROM OUTSIDE OF CORNER (Cycle 414, DIN/ISO: G414)................................................. 308
Cycle run.................................................................................................................................................308
Please note while programming:........................................................................................................... 309
Cycle parameters................................................................................................................................... 309