HEIDENHAIN TNC 320 (34055x-06) Cycle programming - Manual (Page 228)

Cycles: Coordinate Transformations
11.6 ROTATION (Cycle 10, DIN/ISO: G73)
11
228
TNC 320 | User's Manual Cycle Programming | 5/2013
11.6 ROTATION (Cycle 10, DIN/ISO: G73)
Effect
The TNC can rotate the coordinate system about the active datum
in the working plane within a program.
The ROTATION cycle becomes effective as soon as it is defined in
the program. It is also effective in the Positioning with MDI mode
of operation. The active rotation angle is shown in the additional
status display.
Reference axis for the rotation angle:
X/Y plane: X axis
Y/Z plane: Y axis
Z/X plane: Z axis
Resetting
Program the ROTATION cycle once again with a rotation angle of
0°.
Please note while programming:
An active radius compensation is canceled
by defining Cycle 10 and must therefore be
reprogrammed, if necessary.
After defining Cycle 10, you must move both axes of
the working plane to activate rotation for all axes.