HEIDENHAIN TNC 320 (34055x-06) Cycle programming - Manual (Page 20)

Contents
20
TNC 320 | User's Manual Cycle Programming | 5/2013
7.9 CONTOUR TRAIN (Cycle 25, DIN/ISO: G125).................................................................................... 170
Cycle run.................................................................................................................................................170
Please note while programming:........................................................................................................... 170
Cycle parameters................................................................................................................................... 171
7.10 Programming Examples...................................................................................................................... 172
Example: Roughing-out and fine-roughing a pocket.............................................................................. 172
Example: Pilot drilling, roughing-out and finishing overlapping contours............................................... 174
Example: Contour train.......................................................................................................................... 176