HEIDENHAIN TNC 360 User Manual - Manual (Page 94)

TNC 360 5-10
5 Programming Tool Movements
5.4 Path Contours – Cartesian Coordinates
.
.
.
R
+
R
R- L
ENT
ENT
1 e.g. 0 0
TOOL RADIUS COMP.: RL / RR / NO COMP. ?
The tool must move to the left of the programmed contour to com-
pensate its own radius.
The tool must move to the right of the programmed contour to
compensate its own radius.
The tool moves directly to the end point.
FEED RATE F = ? / F MAX = ENT
Enter the feed rate of the tool on the straight line, for example
100 mm/min.
Enter rapid tool traverse, F = FMAX.
MISCELLANEOUS FUNCTION M?
Enter a miscellaneous function, if appropriate, for example M3
(spindle on, clockwise rotation).
Resulting NC block: L IX–50 Y+10 Z–20 RR F100 M3
ENT
3 e.g. ENT