HEIDENHAIN TNC 360 User Manual - Manual (Page 217)

12-7 TNC 360
12 Tables, Overviews, Diagrams
12.1 General User Parameters
Display step for coordinate axes
MP 7290
Function Value
• Display step 0.001 mm .................................................................................................................................... 0
• Display step 0.005 mm .................................................................................................................................... 1
Q parameters and status display
MP 7300
Function Selections Value
• Q parameters and status display Do not erase ................................................................................. +0
Erase with M02, M30 and END PGM .......................................... +1
• Last programmed tool after Do not activate ............................................................................. +0
power interruption Activate ........................................................................................ +4
Graphics display
Entry range: 0 to 3 (sum of the individual values)
MP 7310
Function Selections Value
• View in 3 planes Projection method 1 .................................................................... +0
according to ISO 6433 Projection method 2 .................................................................... +1
• Rotate coordinate system Rotate ........................................................................................... +2
by 90° in the working plane Do not rotate ................................................................................ +0
Parameters for machining and program run
Effect of cycle 11 SCALING
MP 7410
Function Value
• SCALING effective in 3 axes ............................................................................................................................ 0
• SCALING effective in the working plane ......................................................................................................... 1
MP 7411 Tool compensation data in the TOUCH PROBE block
Function Value
• Overwrite current tool data with the calibrated data of the touch probe ......................................................... 0
• Retain current tool data .................................................................................................................................... 1