HEIDENHAIN TNC 360 User Manual - Manual (Page 192)

8-39 TNC 360
8 Cycles
Fig. 8.42: Oriented spindle stop
8.5 Other Cycles
OO
ORIENTED SPINDLE STOP (Cycle 13)
Application
The control can address the machine tool spindle as a 5th axis and turn
it to a certain angular position. Oriented spindle stops are required for:
• Tool changing systems with a defined tool change position
• Orientation of the transmitter/receiver window of the TS 511 Touch
Probe System from HEIDENHAIN
Activation
The angle of orientation defined in the cycle is positioned to with M19. If
M19 is executed without a cycle definition, the machine tool spindle will
be oriented to the angle set in the machine parameters.
Oriented spindle stops can also be programmed in machine parameters.
Prerequisite
The machine must be set up for this cycle.
Input data
Angle of orientation (based on the reference axis of the machining plane)
Input range: 0 to 360°
Input resolution: 0.1°