HEIDENHAIN TNC 360 User Manual - Manual (Page 233)

12-23 TNC 360
12 Tables, Overviews, Diagrams
12.6 TNC Error Messages
GROSS POSITIONING ERROR
The TNC monitors positions and movements. If the actual position
deviates too greatly from the nominal position, this blinking error message
is displayed. To correct the error, press and hold the END key for several
seconds (warm start).
KEY NON-FUNCTIONAL
This message always appears when you press a key that is not needed for
the current dialog.
LABEL NUMBER NOT ALLOCATED
You can only call labels numbers that have been assigned.
PATH OFFSET WRONGLY ENDED
Do not cancel tool radius compensation in a block with a circular
path.
PATH OFFSET WRONGLY STARTED
• Use the same radius compensation before and after a RND and CHF
block.
• Do not begin tool radius compensation in a block with a circular path.
PGM SECTION CANNOT BE SHOWN
• Enter a smaller tool radius.
• Movements in a rotary axis cannot be graphically simulated.
• Enter a tool axis for simulation that is the same as the axis in the BLK
FORM.
PLANE WRONGLY DEFINED
• Do not change the tool axis while a basic rotation is active.
• Define the main axes for circular arcs correctly.
• Define both main axes for CC.
PROBE SYSTEM NOT READY
• Orient transmitting/receiving window of TS 511 to face receiving unit.
• Check whether the touch probe is ready for operation.
PROGRAM-START UNDEFINED
• Begin the program only with a TOOL DEF block.
• Do not resume an interrupted program at a block with a tangential arc
or pole transfer.
RADIUS COMPENSATION UNDEFINED
Enter radius compensation in the first subprogram to cycle 14:
CONTOUR GEOM.