HEIDENHAIN TNC 360 User Manual - Manual (Page 9)

TNC 360
2 Manual Operation and Setup
2.1 Moving the Machine Axes ....................................................................... 2-2
Traversing with the machine axis direction buttons ....................................................... 2-2
Traversing with the electronic handwheel ..................................................................... 2-3
Working with the HR330 Electronic Handwheel ............................................................ 2-3
Incremental jog positioning ............................................................................................ 2-4
Positioning with manual data input (MDI) ...................................................................... 2-4
2.2 Spindle Speed S, Feed Rate F and Miscellaneous Functions M .......... 2-5
To enter the spindle speed S ......................................................................................... 2-5
To enter the miscellaneous function M .......................................................................... 2-6
To change the spindle speed S ...................................................................................... 2-6
To change the feed rate F .............................................................................................. 2-6
2.3 Setting the Datum Without a 3D Touch Probe ...................................... 2-7
Setting the datum in the tool axis .................................................................................. 2-7
To set the datum in the working plane ........................................................................... 2-8
2.4 3D Touch Probe Systems ......................................................................... 2-9
3D Touch probe applications .......................................................................................... 2-9
To select the touch probe menu .................................................................................... 2-9
Calibrating the 3D Touch Probe ...................................................................................... 2-10
Compensating workpiece misalignment ........................................................................ 2-12
2.5 Setting the Datum with the 3D Touch Probe System .......................... 2-14
To set the datum in a specific axis ................................................................................. 2-14
Corner as datum ............................................................................................................. 2-15
Circle center as datum ................................................................................................... 2-17
2.6 Measuring with the 3D Touch Probe System ........................................ 2-19
Finding the coordinate of a position on an aligned workpiece ....................................... 2-19
Finding the coordinates of a corner in the working plane .............................................. 2-19
Measuring workpiece dimensions ................................................................................. 2-20
Measuring angles ........................................................................................................... 2-21