HEIDENHAIN TNC 360 User Manual - Manual (Page 71)

TNC 360 4-6
4 Programming
Fig. 4.2: Tool lengths can be given as the difference from the zero
tool
4.2 Tools
Z
X
L
0
L >0
1
L <0
2
Determining tool length with a zero tool
For the sign of the tool length L:
L > L
0
A positive value means the tool is longer
than the zero tool.
L < L
0
A negative value means the tool is
shorter than the zero tool.
Move the zero tool to the reference position in the tool axis (e.g. workpiece surface with Z = 0).
If necessary, set the datum in the tool axis to 0.
Change tools.
Move the new tool to the same reference position as the zero tool.
The TNC displays the compensation value for the length L.
Write the value down and enter it later.
Enter the display value by using the “actual position capture” function (see page 4-19).