HEIDENHAIN TNC 360 User Manual - Manual (Page 216)

TNC 360 12-6
12 Tables, Overviews, Diagrams
12.1 General User Parameters
Settings for MANUAL OPERATION mode
Entry values 0 to 3:
Sum of the individual values from the “value” column.
MP 7270
Function Selections Value
• Display feed rate in manual mode Display feed rate .......................................................................... +1
Do not display feed rate ............................................................... +0
• Spindle speed S and M functions S and M still active ....................................................................... +0
still active after STOP S and M no longer active .............................................................. +2
Decimal character
MP 7280
Function Value
• Decimal point ................................................................................................................................................... 1
• Decimal comma ............................................................................................................................................... 0