HEIDENHAIN TNC 360 User Manual - Manual (Page 43)

TNC 360 2-5
2 Manual Operation and Setup
Fig. 2.4: Knobs for spindle speed and feed
rate overrides
1 e.g. 0 0 0
ENT
TOOL
CALL
I
2.2 Spindle Speed S, Feed Rate F and Miscellaneous Functions M
The following values can be entered and changed in the MANUAL OPER-
ATION AND ELECTRONIC HANDWHEEL modes of operation:
• Miscellaneous function M
• Spindle speed S
• Feed rate F (can be changed but not entered)
For part programs these functions are entered or edited directly in the
PROGRAMMING AND EDITING operating mode.
To enter the spindle speed S:
Initiate the dialog with the TOOL CALL key.
SPINDLE SPEED S RPM ?
Enter the spindle speed S, for example 1000 rpm.
Confirm the spindle speed S with the machine START button.
A miscellaneous function M starts spindle rotation at the entered
speed S.