HEIDENHAIN TNC 360 User Manual - Manual (Page 136)

TNC 360 7-2
7 Programming with Q Parameters
Fig. 7.1: Q parameters as variables
Q Parameters are used for:
• Programming families of parts
• Defining contours through mathematical functions
A family of parts can be programmed in the TNC in a single part pro-
gram. You do this by entering variables — called Q parameters — instead
of numerical values.
Q parameters can represent for example:
• Coordinate values
• Feed rates
• Spindle speeds
• Cycle data
A Q parameter is designated by the letter Q and a number between 0 and
113.
Q parameters also enable you to program contours that are defined
through mathematical functions.
With Q parameters you can make the execution of machining steps
dependent on logical conditions.
Q parameters and numerical values can also be mixed within a pro-
gram.
The TNC automatically assigns data to some Q parameters. For example, parameter Q108 is assigned the current
tool radius. You will find a list of these parameters in chapter 12..
Q4
Q2
Q3
Q1
Q5
Q6