HEIDENHAIN TNC 360 User Manual - Manual (Page 198)

9-7 TNC 360
9 Digitizing 3D Surfaces
e.g.
9.3 Line-By-Line Digitizing
.
.
.
0 8 .
MAX. PROBE POINT INTERVAL ?
Enter the maximum probe point interval, for example 0.8 mm.
Resulting NC blocks:
TCH PROBE 6.0 MEANDER
TCH PROBE 6.1 DIRECTN: X
TCH PROBE 6.2 TRAVEL: 0.5 L.SPAC: 0.2
P.P. INT: 0.8
Before cycle 6: MEANDER the program must have a range defined in digitizing cycle 5: RANGE.
ENT