Grass Valley Xbuilder Vertigo Suite v.4.8 - Manual (Page 65)

Xbuilder User Manual 6-3
Creating and using playlists
Procedural overview for creating a sequential playlist
The procedure below identifies the high-level steps involved in creating playlists for playing
out branding and promotional graphics sequences. Subsequent sections (identified by the
links within the procedure) provide step-by-step instructions for performing each step.
To create a sequential playlist in Xbuilder:
1. Create a new playlist, or open an existing playlist.
•
“Creating a new playlist” on page 6-4
• “Opening an existing playlist” on page 6-4
• “Verifying the contents of a playlist” on page 6-5
2. Populate the playlist with pages, scenes, clips, and/or the contents of other playlists
•
“Creating and adding an embedded page to a playlist” on page 6-7
• “Adding shared pages, scenes and clip assets to a playlist” on page 6-8
• “Appending or inserting the contents of a playlist to a playlist” on page 6-9
3. Determine which property columns you want displayed in the playlist.
•
“Configuring the Playlist table columns” on page 6-11
4. Organize the playlist items
•
“Repositioning playlist items within the playlist” on page 6-17 (optional)
• “Adding segments to the playlist” on page 6-19 (optional)
• “Adding comments to the playlist” on page 6-21 (optional)
• “Deleting playlist items from the playlist” on page 6-22 (optional)
5. Edit the playlist items’ properties
•
“Editing the properties associated to the playlist items” on page 6-24
6. Save the playlist
•
“Saving a playlist” on page 6-26
Additional tasks that can be performed using the playlist are:
•
“Reloading the playlist” on page 6-28