Place holders settings, Place holders settings -9 – Grass Valley Xbuilder Vertigo Suite v.4.8 User Manual
Page 141
Xbuilder User Manual
9-9
Appendix B - Quick reference to Xbuilder’s settings
Place Holders settings
Within a WorkOrder Job, a place holder can be created for an image or clip. A place holder
is an empty asset that serves as a place holder for an image or clip that will be obtained
later by completing the associated WorkOrder Job.
Figure 9-6. Place Holders settings
•
Images place holder default category - Specifies the category in which new image
place holders are saved. If unspecified, image place holders are saved to in the same
category as the image from which the place holder is created.
•
Clips place holder default category - Specifies the category in which new clip place
holders are saved. If unspecified, clip place holders are saved to the same category as
the clip from which the place holder is created.