Grass Valley Xbuilder Vertigo Suite v.4.8 - Manual (Page 50)

5-4 Vertigo Suite v.4.6 Release Notes (GA)
Performing Quality Control (QC) and Media Check (MC)
4. Assign publish devices to the Approved Category folders.
a.
Right-click on the new Approved Category folder in the Clips root category and
select the P
ROPERTIES command.
The P UBLISH D EVICES dialog box appears.
b. Select the device(s) that you want the assets to be automatically published to and
then click OK.
c. Repeat steps a and b for the Approved Category folder in the CelAnimations root
category.
Specify Xbuilder’s settings for the QC and MC workflows
To accommodate the QC and MC workflows, a few of Xbuilder’s settings must be configured.
To configure Xbuilder’s settings for the QC workflow:
1.
Launch Xbuilder.
2. In the D EVICE FOR V ERIFY drop-down list, select U SE P LAYLIST D EVICES (figure 5-2 ).
Figure 5-2. Set Xbuilder’s Device for Verify parameter to “Use Playlist Devices”
3. Open Xbuilder's S ETTINGS dialog box (T OOLS >S ETTINGS ).
Figure 5-3. Xbuilder’s Settings
4. Set the X BUILDER >G ENERAL >V ERIFY PLAYLIST parameter to M ANUAL .
5. Set the X BUILDER >G ENERAL >N UMBER OF V ERIFY D EVICES to the number of devices that
you expect to use for verifying assets.
6. Click OK in the S ETTINGS dialog box to apply the new settings and close the dialog box.