Grass Valley Profile XP Service Manual - Manual (Page 116)

Chapter 11 Parts removal and replacement
116 Profile XP Service Manual 23 July 2004
c. In the Network window, change the computer name and network addresses as
needed. Check with your system administrator for the correct information to
enter. For more information about setting up the network, refer to the Profile XP
System Guide.
14. Close all open windows and restart the Profile XP system to activate the changes.
15. Log on as administrator (password triton) when the system has rebooted.
16. Use Windows NT Explorer (or My Computer) to verify the presence of
C:\pdrmovie_db.
17. Load the system software. You can use the current production version of Profile
Software located in C:\Software, or if you prefer, you can use a version from your
own CD ROM or from a network drive.
a. Use Windows NT Explorer to run Disk 1\Setup.exe.
b. Follow the directions, being sure to select “Yes, I want to restart…” in the Setup
Complete window.
18. Log on as administrator.
19. Start the Configuration Manager.
20. If you have a saved configuration file, open it using File | Open .
21. Configure the Profile XP system for Video, Audio, and Fibre Channel to
accommodate your needs. Refer to the Profile XP System Guide for information
about using Configuration Manager.
22. When the configuration is complete, use File | Save a Copy to store the
configuration in the C:\profile\config directory and to floppy disk or a network
drive for backup.
23. Reload your application software such as TimeDelay, NetCentral Lite, Toolbox
Editor, etc.
24. Reconfigure NetCentral settings including the SNMP Traps. See the System
Software Release Notes.