Grass Valley Kayak HD Installation v.6.8.8 - Manual (Page 82)

82 Kayak HD — Installation and Service Manual
Section 2 — Installation
9. Now set the Phase as close as possible to the average number.
10. Recheck all video sources on AUX1 for timing. Fine tune the Phase
adjustments if necessary.
There will always be a few video sources that may be out of legal timing
range, even after you have adjusted the switcher for the best average
timing for all sources. In that case, you need to go to the video source
itself and adjust its timing.
11. Check the Asynchronous buses display. If any buses are displayed or
blinking, that bus input is not in sync and the timing for its video
sources must be re-adjusted.
CAUTION If you change the Video Standard setting in the Genlock menu, you must go
back and check the timing for all video sources once again.
Note If you add additional M/Es to your switcher you must also recalibrate your
video timing to make sure all sources are within the new smaller green legal
timing window.