Grass Valley Kayak HD Installation v.6.8.8 - Manual (Page 103)

Kayak HD — Installation and Service Manual 103
Assigning Permanent Sources to AUX Buses
The input Source you selected is now renamed with the name you chose
(
Figure 63 on page 103 ).
Figure 63. Renamed Source
You can also press Modify Lng N to change the Long Name of a button. The
Long Name can be a slightly longer name you might use in the Kayak
control panel menus to describe the source in more detail. To modify the
Long Name use the same procedure described in Rename Sources
on
page 100 but press the Modify Lng N button to change the Long Name in
Step 5 .
Assigning Permanent Sources to AUX Buses
The default output configuration of a Kayak system maps Aux 1 to output
BNC 1, Aux 2 to BNC 2, etc. You will probably want to permanently assign
your program output (
Main or MEH ) to the Aux bus feeding your program
monitor, and the preview output ( PVWP or PVWH ) to the Aux bus feeding
your preview monitor.
Use the Install - EBox - AUX menu to assign permanent sources to AUX bus
output BNCs.
8448_36_
r0